B&W Daisy Necklace and Bracelet

By Spotlight

Featured in our VIP Catalogue ' Find and Create'

Final Result

Materials

You will need the following from the Ribtex Inspirations range:
1 x DBX051D Bead Kit Flower Oval White/Silver 30g
1 x DBX051D Bead Kit Flower Oval Black/Silver 30g
1 x DBX051D Bead Kit Disco Round White/Silver 30g
1 x DBX051D Bead Kit Disco Round Black/Silver 30g
2 x JF868 Ribtex Oval Metal Ring 20x40mm Silver 6pcs
2 x JF402 Ribtex Eye Pins 35mm Dark Silver 10pcs
1 x JF468 Ribtex Jump Rings 4mm Dark Silver 40pcs
1 x JF330 Ribtex Chain Oval Link 5x3mm Silver 1m

Additional Requirements:
JF165 Ribtex Cutter Pliers
JF166 Ribtex Round Nose Pliers
Scissors

Step 1

Necklace:

Thread the following beads onto eye pins, 5 x black
flowers, 4 x white flowers, 4 x white oval, 1 x black
oval, 3 x black disco (2 per eye pin) and 1x white disco
(2 per eye pin).

Step 2

Using pliers cut the eye pins leaving approximately 1cm of
pin above the bead. Bend the excess pin to a 45 degree
angle using round nose pliers. Then turn the ends into loops.

Step 3

Using jump rings connect the beaded eye pins to 9 oval rings so the
flowers alternate in colour. Start and finish the length of necklace with the oval rings.

Step 4

Cut a length of chain 10cm long (make the chain length longer if you want a longer necklace) and use jump rings to
attach the chain to the oval rings to complete the necklace.

Step 5

Bracelet

Cut 2 lengths of stretch thread approximately 25cm long.

Step 6

Thread onto both strands a black flower bead which will be the centre bead.

Step 7

hread onto one side of the centre flower bead the following combination:
3 x disco or oval beads, 1 x white flower, 3 x disco or oval beads.

Step 8

Then thread the same combination onto the other side and add an
extra black flower and an extra 2 beads on the end.

Step 9

To finish the bracelet, tie the ends of the stretch thread securely.